Updated Aug 13, 2022 Certification Exam JN0-663 Dumps - Practice Test Questions [Q40-Q59]

Rate this post

Updated Aug 13, 2022 Certification Exam JN0-663 Dumps – Practice Test Questions

Updated Verified JN0-663 dumps Q&As – Pass Guarantee or Full Refund

Conclusion

Completing the JNCIP-SP JN0-663 exam is a brilliant decision in your networking career and you can easily succeed in this test with the right resources and training. In the first place, you need to check out the vendor’s site for the official courses available there. The second sensible step will be to find and use the comprehensive study guides from Amazon that will make your preparation for the final validation smooth and efficient.

Q40. Exhibit:

Referring to the exhibit, which path would traffic passing through R1 take to get.

R1 -> R2 -> R4 -> R6

R1 -> R2 -> R3 -> R6

R1 -> R3 -> R5 -> R6

R1 -> R3 -> R4 -> R6

Q41. Exhibit:

Referring to the exhibit, which statement is true?

The route is learned from only one neighbor.

This is a multipath route.

The route is learned from three different neighbors.

This is a multihop route.

Q42. Exhibit:

Referring to the exhibit, which three statements about route 10.222/16 are correct when using the default BGP advertisement rules? (Choose three)

R2 will advertise 10.222/16 to R4 with itself as the next hop.

R2 will prepend AS10 when advertising 10.222/16 to R7.

R7 will advertise 10.222/16 to R9 with itself as the next hop.

R1 will advertise 10 222/16 to R2 with itself as the next hop.

R1 will prepend AS10 when advertising 10.222/16 to R2.

Q43. Exhibit:

You are troubleshooting BGP routing issues between two MX Series routers. The BGP session is established but no BGP routes are being communicated.
What are two reasons for this problem? (Choose two.)

The peer type should be external.

No active BGP routes are in the inet.0 table

table ii No export routing policy is applied.

The peers are in different ASs.

Q44. Exhibit:

All adjacencies have been formed, no extra options have been configured, and no policies have been written.
Referring to the exhibit, which two statements are correct? (Choose two.)

R1 cannot reach R5

R1 will create its own default route that points to R2

R2 will create a default route and send it as a TLV to R1

R1 can reach R5.

Q45. Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

This router is an ABR

This router is an ASBR.

There are two interfaces marked as passive.

There is one interface marked as passive.

Q46. Exhibit:

You must configure an OSPF virtual link to facilitate communication between Area 0 and Area 20.
Referring to the exhibit, which two addresses should you use as the neighbor IDs of the virtual link endpoints?
(Choose two.)

The address that is associated with R2’s router ID.

The address that is associated with R4’s router ID.

The address that is associated with R2’s xe-1/2/0 interface.

The address that is associated with R4’s xe-0/0/1 interface.

Q47. Exhibit:

Referring to the exhibit, which statement is true?

The route is learned from only one neighbor.

This is a multipath route.

The route is learned from three different neighbors.

This is a multihop route.

Q48. Exhibit.

You are troubleshooting a problem with a BGP peer where BGP routes are not being accepted from that peer Referring to the exhibit, which two statements are correct*? (Choose two )

Term 0 is missing a terminating action that allows BGP routes to be accepted

You cannot have terminating actions outside of terms.

The reject at the end of the policy is preventing the routes from being accepted.

Term 0 is missing a route-fitter that specifies the allowed routes

Q49. You are asked to configure a series of interface policers and firewall filters, which include policers, on the same device You must ensure that the two configuration methods do not conflict.
What are two considerations when performing this task? (Choose two.)

On inbound traffic, interface policers are applied before firewall filters.

On inbound traffic, firewall filters are applied before interface policers.

On outbound traffic, interface policers are applied before firewall filters.

On outbound traffic, firewall filters are applied before interface policers.

Q50. Exhibit:

R2 is receiving a route from R1 and you must ensure that the route is not advertised to R3.
Referring to the exhibit, which two configurations on R2 will solve the issue? (Choose two.)

Apply the no-export policy as an import policy under group 65001

Apply the no-advertise policy as an export policy under group 65003

Apply the no-export policy as an export policy under group 65003

Apply the no-advertise policy as an import policy under group G5001

Q51. Exhibit:

Referring to the exhibit, hosts in Site 1 and Site 2 are unable to communicate with each other through the Layer 3 VPN.
What is the problem?

The two sites are using the same route distinguishes.

The two sites are in the same AS.

The two sites are using the same instance type.

The two sites are using the same route target.

Q52. Exhibit:

Referring to the exhibit, which three statements are correct? (Choose three.)

This route contains the MAC address of an end host.

The router with the IP address 10.101.100.3 is the originator of this route.

This route is an EVPN Type-1 route.

This ESI Auto-Discovery route is used for designated forwarder election.

The ESI is 00:22:22:22:22:22:22:22:22:22.

Q53. Exhibit:

You are troubleshooting an issue where R1 is no longer receiving the default IS-IS route from R3.
Referring to the exhibit, which action would you take to solve the problem?

Delete the protocols isis ignore-attached-bit configuration statement on R3.

Delete the protocols isis import configuration statement on R1.

Delete the protocols isis level 2 disable configuration statement on R3.

Delete the protocols isis ignore-attached-bit configuration statement on R1.

Q54. You have a mixed vendor EVPN environment and you need to ensure VXLAN interoperability between all devices In this scenario which statement is correct?

You should only use Type 6 and Type 2 routes

You should only use pure Type 2 routes

You should only use Type 2 and Type 5 routes.

You should only use pure Type 5 routes

Q55.

You are provisioning Layer 2 circuits between sites CE1, CE2, and CE3.
Referring to the exhibit, which statement is true?

A point-to-multipoint LSP must be created between sites.

Each site must have only one VLAN configured to the PE.

Site PE1 must have a point-to-multipoint link configured towards the core.

Two VLANs must be configured from PE 1 to CE 1.

Q56. Exhibit:

The exhibit shows a BGP peering session for two PE routers. The BGP session is up, but the hosts in the Layer
2 VPN that uses the BGP session are unable to communicate.
What is the problem in this situation?

The BGP peer does not support the restarter functionality.

The local BGP router does not support Layer 2 VPN and Layer 3 VPN NLRI address families at the same time.

There is a mismatch in the supported NLRI address families between the BGP peers.

The BGP peer does not support the add-path feature.

Q57.

Your router should be configured with a rewrite rule which alters the default behavior of expedited forwarding as shown in the exhibit.
In this scenario, which configuration is correct?

Q58. Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

An AS loop will not exist between CE-1 and CE-2 and the BGP routes will be shared.

The CE-1 and CE-2 routes will have the same route distinguisher, which will stop the BGP routes from being shared.

An AS loop will exist between CE-1 and CE-2 and the BGP routes will not be shared.

The CE-1 and CE-2 routes will have the same route distinguisher, which will not stop the BGP routes from being shared.

Q59. You have a mixed vendor EVPN environment and you need to ensure VXLAN interoperability between all devices.
In tins scenario, winch statement is correct?

You should only use pure Type 2 routes.

You should only use pure Type 5 routes.

You should only use Type 2 and Type 5 routes.

You should only use Type 6 and Type 2 routes.

Loading …