Changing the Concept of NSE4_FGT-7.0 Exam Preparation 2024 [Q105-Q119] : Testking Free Dumps : http://blog.testkingfree.com

QUESTION 105
Examine this PAC file configuration.

Which of the following statements are true? (Choose two.)

Browsers can be configured to retrieve this PAC file from the FortiGate.

Any web request to the 172.25.120.0/24 subnet is allowed to bypass the proxy.

All requests not made to Fortinet.com or the 172.25.120.0/24 subnet, have to go through altproxy.corp.com: 8060.

Any web request fortinet.com is allowed to bypass the proxy.

QUESTION 106
Refer to the exhibit.

Based on the administrator profile settings, what permissions must the administrator set to run the diagnose firewall auth list CLI command on FortiGate?

Custom permission for Network

Read/Write permission for Log & Report

CLI diagnostics commands permission

Read/Write permission for Firewall

QUESTION 107
Which three methods are used by the collector agent for AD polling? (Choose three.)

FortiGate polling

NetAPI

Novell API

WMI

WinSecLog

QUESTION 108
Examine the network diagram shown in the exhibit, then answer the following question:

Which one of the following routes is the best candidate route for FGT1 to route traffic from the Workstation to the Web server?

172.16.0.0/16 [50/0] via 10.4.200.2, port2 [5/0]

0.0.0.0/0 [20/0] via 10.4.200.2, port2

10.4.200.0/30 is directly connected, port2

172.16.32.0/24 is directly connected, port1

QUESTION 109
Refer to the exhibits.

The SSL VPN connection fails when a user attempts to connect to it. What should the user do to successfully connect to SSL VPN?

Change the SSL VPN port on the client.

Change the Server IP address.

Change the idle-timeout.

Change the SSL VPN portal to the tunnel.

QUESTION 110
An administrator is configuring an IPsec VPN between site A and site B.
The Remote Gateway setting in both sites has been configured as Static IP Address. For site A, the local quick mode selector is 192.168.1.0/24 and the remote quick mode selector is 192.168.2.0/24.
Which subnet must the administrator configure for the local quick mode selector for site B?

192.168.1.0/24

192.168.0.0/24

192.168.2.0/24

192.168.3.0/24

QUESTION 111
Refer to the exhibit.

The exhibit displays the output of the CLI command: diagnose sys ha dump-by vcluster.
Which two statements are true? (Choose two.)

FortiGate SN FGVM010000065036 HA uptime has been reset.

FortiGate devices are not in sync because one device is down.

FortiGate SN FGVM010000064692 is the primary because of higher HA uptime.

FortiGate SN FGVM010000064692 has the higher HA priority.

QUESTION 112
An administrator has configured the following settings:

Device detection on all interfaces is enforced for 30 minutes.

Denied users are blocked for 30 minutes.

A session for denied traffic is created.

The number of logs generated by denied traffic is reduced.

QUESTION 113
Refer to the exhibit.

A network administrator is troubleshooting an IPsec tunnel between two FortiGate devices. The administrator has determined that phase 1 fails to come up. The administrator has also re-entered the pre-shared key on both FortiGate devices to make sure they match.
Based on the phase 1 configuration and the diagram shown in the exhibit, which two configuration changes will bring phase 1 up? (Choose two.)

On HQ-FortiGate, set IKE mode to Main (ID protection).

On both FortiGate devices, set Dead Peer Detection to On Demand.

On HQ-FortiGate, disable Diffie-Helman group 2.

On Remote-FortiGate, set port2 as Interface.

QUESTION 114
You have enabled logging on your FortiGate device for Event logs and all Security logs, and you have set up logging to use the FortiGate local disk.
What is the default behavior when the local disk is full?

Logs are overwritten and the only warning is issued when log disk usage reaches the threshold of 95%.

No new log is recorded until you manually clear logs from the local disk.

Logs are overwritten and the first warning is issued when log disk usage reaches the threshold of 75%.

No new log is recorded after the warning is issued when log disk usage reaches the threshold of 95%.

QUESTION 115
How do you format the FortiGate flash disk?

Load a debug FortiOS image.

Load the hardware test (HQIP) image.

Execute the CLI command execute formatlogdisk.

Select the format boot device option from the BIOS menu.

QUESTION 116
Refer to the exhibit.

The exhibit contains a network diagram, central SNAT policy, and IP pool configuration.
The WAN (port1) interface has the IP address 10.200.1.1/24.
The LAN (port3) interface has the IP address 10.0.1.254/24.
A firewall policy is configured to allow to destinations from LAN (port3) to WAN (port1).
Central NAT is enabled, so NAT settings from matching Central SNAT policies will be applied.
Which IP address will be used to source NAT the traffic, if the user on Local-Client (10.0.1.10) pings the IP address of Remote-FortiGate (10.200.3.1)?

10.200.1.149

10.200.1.1

10.200.1.49

10.200.1.99

QUESTION 117
Examine this FortiGate configuration:

How does the FortiGate handle web proxy traffic coming from the IP address 10.2.1.200 that requires authorization?

It always authorizes the traffic without requiring authentication.

It drops the traffic.

It authenticates the traffic using the authentication scheme SCHEME2.

It authenticates the traffic using the authentication scheme SCHEME1.

QUESTION 118
What inspection mode does FortiGate use if it is configured as a policy-based next-generation firewall (NGFW)?

Full Content inspection

Proxy-based inspection

Certificate inspection

Flow-based inspection

QUESTION 119
Refer to the exhibit.

Based on the raw log, which two statements are correct? (Choose two.)

Traffic is blocked because Action is set to DENY in the firewall policy.

Traffic belongs to the root VDOM.

This is a security log.

Log severity is set to error on FortiGate.

Changing the Concept of NSE4_FGT-7.0 Exam Preparation 2024 [Q105-Q119]

For detailed info about the NSE 4 Network Security Professional, click below